Sound and Recording - Achieving a Brighter Vocal

Sound and Recording
B. Thomas Cooper
Editor

Let me guess,
Your lead singer doesn't seem bright enough. Chances are, he isn't.

Don't be too hard on him. It may be no fault of his own. Try as he might, his vocals simply won't cut through the dense fog rolling from the rhythm section. It's a common problem, and one I'll attempt to address, although I'll readily admit a little trepidation.

Much is dependent on the sound pressure levels in respect to the timber and projection abilities of the vocalist. Obviously, a live performance presents a considerably different set of variables than that of a studio recording. The two are as different as they are the same.

A brighter' vocal sound can be achieved a number of ways. Start by choosing an appropriate microphone. Unfortunately, what may seem the right mic tonight may not seem right tomorrow. When changes occur, even subtle ones, it often becomes necessary to switch microphones. An aware engineer may even determine to swap microphones from one song to the next.

Good microphone technique and proper singing habits will profoundly effect your vocal performance. A mic can only capture what you produce. Once the performance has been captured, it can be enhanced through various means, including reverbs, compression, etc. but all the reverb in the world will not drown out a bad performance.

A bright' vocal will tend to cut through the mix, like a megaphone, or the p.a. system at the racetrack. However, it is worth noting that a bright' vocal risks becoming strident, or worse a shrill distraction, plagued by incessant feedback. Sound familiar?

The cure requires patience and practice. Learn all you can about your craft,
and don't assume you know all the answers. Just keep plugging away, and before you know it, you'll be performing to sold out crowds of adoring fans, at which point you may conclude your vocalist seems a little brighter than usual.